1/2" x 8-1/4" SDS Plus Masonry Drill Bit – Carbide Tip
This 1/2" x 8-1/4" SDS Plus masonry drill bit drills clean anchor and fastener holes in concrete, brick, block and stone. The slotted SDS Plus shank locks into any SDS Plus rotary hammer and lets the bit hammer freely while it turns, so it bores through masonry fast.
A carbide cutting tip holds its edge in abrasive material, and the spiral flutes pull dust out of the hole as you drill. Keep one on the truck for setting anchors for flashing, brackets, ledger boards and conduit straps.
Why Contractors Choose It
🔨 SDS Plus shank — locks into any SDS Plus rotary hammer
🧱 Carbide tip — bores concrete, brick, block and stone
📏 1/2" diameter x 8-1/4" overall length
🌀 Spiral flutes — clear dust out of the hole as you drill
⚓ Sized for anchors — brackets, ledgers, flashing and straps
🛠️ Jobsite tough — made for hammer-drill use
How To Use
1️⃣ Mark the hole and insert the shank into the SDS Plus chuck until it clicks.
2️⃣ Set the hammer drill to rotary hammer mode.
3️⃣ Start slowly to seat the tip, then drill with steady pressure.
4️⃣ Back out often to clear dust, and blow the hole clean before setting an anchor.
Notes
Type: SDS Plus masonry drill bit
Diameter: 1/2"
Overall Length: 8-1/4"
Usable Length: 6-1/4"
Shank: SDS Plus
Tip: Carbide
Material: Concrete, brick, block and stone
Use with SDS Plus rotary hammers only
Wear eye protection when drilling
⚠️ California Proposition 65 Warning
This product may expose you to chemicals including metals known to the State of California to cause cancer or reproductive harm. For more information visit www.P65Warnings.ca.gov.