Dasco Pro 7" All Metal Scratch Awl β One-Piece Forged Steel, #431
The Dasco Pro 431 All Metal Scratch Awl is a 7" one-piece tool for scribing layout lines and starting holes. Use it to mark sheet metal, flashing, wood and trim, or to start a hole for a screw or nail in material softer than the point.
It's forged from a single piece of high carbon steel, so there's no handle to loosen or split, and the sharp point is heat-treated to hold up on the job. The 3-1/2" shank has a blue finish, and the awl is made in the USA.
Why Contractors Choose It
π© One-piece forged steel β no handle to loosen, crack or split
π Sharp heat-treated point β scribes clean layout lines
π³οΈ Starts holes β for screws and nails in wood and soft materials
π 7" overall length β 3-1/2" shank for reach and control
π¨ All-metal body β tough enough for the tool bag
πΊπΈ Made in the USA
How To Use
1οΈβ£ Mark your layout points on the material.
2οΈβ£ Hold the awl like a pencil to scribe a line, or upright to start a hole.
3οΈβ£ Press or twist the point into the mark to set a pilot hole.
4οΈβ£ Wear eye protection and cap or store the point safely after use.
Notes
Model: 431
Type: Scratch awl, all metal
Overall Length: 7"
Shank Length: 3-1/2"
Material: One-piece forged high carbon steel, heat-treated point
Finish: Blue
Made In: USA
Wear safety goggles when in use
β οΈ California Proposition 65 Warning
This product may expose you to chemicals including metals known to the State of California to cause cancer or reproductive harm. For more information visit www.P65Warnings.ca.gov.