Hole Saw Arbor – 7/16" Hex Shank, 5/8"-18 Thread, for 1-1/4" to 6" Hole Saws
This hole saw arbor mounts 1-1/4" to 6" hole saws with a 5/8"-18 thread for cutting clean holes in wood, plastic and metal. The 7/16" hex shank grips tight in a 1/2" drill chuck without spinning.
Drive pins lock into the back of the hole saw for a solid, wobble-free connection that won't bind the threads, so the saw comes off easily after the cut. A replaceable high speed steel pilot drill starts the hole right on your mark.
Why Contractors Choose It
🔩 5/8"-18 thread — fits 1-1/4" to 6" hole saws
📌 Drive pins — solid, wobble-free connection
⚙️ 7/16" hex shank — won't spin in the chuck
🎯 HSS pilot drill — accurate starts, replaceable
🔓 Easy saw removal — pins carry the load, not the threads
🛠️ For vents, pipe boots, conduit and plumbing holes
How To Use
1️⃣ Thread the hole saw onto the arbor and lock the drive pins into the saw.
2️⃣ Tighten the 7/16" hex shank in a 1/2" drill chuck.
3️⃣ Set the pilot drill on your mark and cut at a steady, moderate speed.
4️⃣ Back the pins off after the cut and unthread the saw to remove it.
Notes
Type: Hole saw arbor
Shank: 7/16" hex
Thread: 5/8"-18
Fits: 1-1/4" to 6" hole saws
Pilot Drill: High speed steel, replaceable
Use with a 1/2" chuck drill
⚠️ California Proposition 65 Warning
This product may expose you to chemicals including metals known to the State of California to cause cancer or reproductive harm. For more information visit www.P65Warnings.ca.gov.